Click image to view full size image
Product information
1.MY series : from MY-00 to MY-6 total 8 sizes .
2.Out put max-torque from 500Nm to 8,500Nm3.Ratio from 33:1 to 67:1
4.Housing material : ductil iron , cast steel , stainless steel or low temperature steel
5.Stem nut material: ductil iron ,bronze
6.Worm is ASTM 1045 heat treated carbon steel.
7.Connection flange DIN ISO5211
8.Protection grade can be IP67,IP68 or immersed ,all according to customers requirements
Features
1.Small in volume, light in weight, reasonable design and strong in output, labor saving and portable.
2.The device are equipped with limit screws which can be adjusted within 5 degree at position in open and close.
3.Indicator board of open degree is directly installed on output worm gear,so indication is accurate and audio-visual.
4.There are two keyways apart with 90 degree set on the inner hole of worm gear for need.
5. The output flange accords with standard ISO5211 and can be machined as customers' special requirements.
6.The dedicated grease has been loaded before leaving factory, the shell is sealed up for waterproof.
MY Series worm gear actuator ,quarter turn worm gear operator
